Metric Threads on an Imperial Lathe
You might well have read my write up on how I implemented the Clough42 Electronic Leadscrew on my Myford Super 7 Large Bore lathe.
While I have been successfully using the ELS as an automatic feed, I had put off attempting screw thread cutting. You know how it is. Screw cutting is nagging at you to try, but it is on the ‘too difficult’ pile pending other more interesting jobs. There is always something else to do, so you kid yourself it is justified to put it off until another day. Well another ‘lockdown’ day dawned and I decided today was the day.
My experiences are recorded here as a full write up
Screw cutting using the Clough42 ELS
Similar or related subjects : –
- Parting Off on the Lathe
- Workshop storage update using Spacemaster 5L boxes
- Plastic heat sealer – a useful workshop asset
- How to square up a scrap piece of stock ready for machining
- Deburring techniques in the home workshop
- Machining a job that is outside a milling machine’s table travel using Fusion 360
- Stevenson Collet Block and the Angle of Dangle
- A Lazy Cable Clamp using 3D Printing
- Mill Turning Jig
- You say Vise and I say Vice but we agree that Clamps are Clamps