Making life easier on cut threads
Minor tip – You have a thread that is too long. You hacksaw it down to length and then have the pain of cleaning the end up so it looks square and more importantly the thread will start. If you are organised you will probably spin a nut onto the thread and use this to clear the cut end thread.
Step up the Noga Classic Rotadrive external deburring tool. This is meant to take a burr off the end of a cut rod but is equally good for clearing the start of a cut thread. File the cut end flat and spin the Noga on the end for a couple of spins. Magic. Admittedly you can’t go down to diameters less than 4mm but below this size threads are usually not quite so difficult to start after cutting.
Links to similar or related post are listed below : –
- Dry lining wall fastener fixing aid
- Simple Vice tommy bar modification
- Soldering Iron bit storage on Lytool soldering station
- Water Softener goes AWOL
- Technoline Wireless Weather Station problem
- Using Raaco section boxes for fastener storage
- Bamboo barbeque sticks as dowels
- Spreadsheet Compendium by Popular Request
- Spreadsheet for setting a lathe compound slide angle
- Shopping list spreadsheet that has other uses
- Dry lining wall fastener fixing aid
- Simple Vice tommy bar modification
- Soldering Iron bit storage on Lytool soldering station
- Water Softener goes AWOL
- Technoline Wireless Weather Station problem
- Using Raaco section boxes for fastener storage
- Bamboo barbeque sticks as dowels
- Spreadsheet Compendium by Popular Request
- Spreadsheet for setting a lathe compound slide angle
- Shopping list spreadsheet that has other uses
